Instructions-1
ZYPPAH IS 91% EFFECTIVE
NOT SURE IF YOU HAVE THE RIGHT FIT?
EMAIL: WECARE@ZYPPAH.COM
EVERYTHING YOU NEED
1. Your ZYPPAH Appliance
2. Two (2) Quarts of Water
3. Metal kitchen Utensil (Tongs)
4. Timer
5. Small Mirror
6. Towel or Paper Towels
7. Microwave-Safe Container
Heat up (2) quarts of water to almost a boil, then transfer the hot water to a microwave-safe container deep enough to submerge the entire appliance
Remember the water should be hot and not boiling when dropping the ZYPPAH in.
NOTE: Use care when handling the device and the hot water during custom fitting, as both will be extremely hot.
Use the kitchen utensil to gently immerse the ZYPPAH in water. Let the appliance soak in the hot water for 30-45 seconds.
The appliance will try to float. Use the utensil to keep itunder water and from touching the sides or the bottom where it may try to stick to the bowl.
Carefully pick up your ZYPPAH by the tongue strap and remove it from the hot water.
While holding the tongue strap using the kitchen utensil, wait 5 to 10 seconds until it is warm to the touch.
NOTE: Use care when handling the device and the hot water as both may be extremely hot.
Start with your lower teeth and press the appliance down with your fingers.
Move your lower jaw forward to align the top of the appliance with yur upper teeth and bite down and hold for one minute.
Make sure to get a very good impression of your teeth when you bite down and your tongue is under the elastic band.
Rinse and Set
Remove ZYPPAH from your mouth and rinse under cool water for 30 seconds. This will properly set the appliance to your bite.
Cleaning
Z Clean is recommended, but you may also clean the appliance with water or mouthwash and rinse.
Do not soak your appliance in any cleaning solution as it will deteriorate your appliance.
WATCH NOW:
Follow along with
Dr. Jonathan Greenburg,
Inventor of ZYPPAH
ZYPPAH User Manual
